test
Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • buzzfrankel Friend
    #119714

    How can I make the flash header image start with a specific image? I would assume that it would begin using alphabetical/numerical order but in my header-it seems to begin with “header_image3.jpg” rather than “header_image1.jpg”.

    Please help.

    Thanks,
    Adam

    ErikThorsen Friend
    #218138

    I think we would need to see a live URL or something to be able to assist you. I also seem to remember something about this in another post. Have you tried to search the forum for your solution?

    buzzfrankel Friend
    #218226

    I have searched the forum but I have not found an answer.

    Here is the URL:
    http://www.emotionprinting.com/Mastiff
    You’ll notice that the flash header begins with the image of a couple’s feet on the beach. The feet image is “header_image4.jpg”. I have “header_image1.jpg” through “header_image5.jpg”.

    So-to try and clarify-I have the following images:
    header_image1.jpg (beach)
    header_image2.jpg (father n child)
    header_image3.jpg (golf)
    header_image4.jpg (feet)
    header_image5.jpg (kids soccer)

    But, you’ll notice that the images rotate in the following order:
    header_image4.jpg (feet)
    header_image1.jpg (beach)
    header_image2.jpg (father n child)
    header_image5.jpg (kids soccer)
    header_image3.jpg (golf)

    I am fairly certain that I have the module parameters set correctly.

    Let me know if you have any ideas.

    Thanks again,
    Adam

    davidp Friend
    #218846

    Hi Adam,

    There is quite a simple soution to this one which it took me some time to figure out:

    Just rename your files to 1.jpg, 2.jpg etc (in the order you want them to appear). Or: 1picture.jpg, 2photo.jpg etc

    I hope that helps =)

    Best regards,
    David

Viewing 4 posts - 1 through 4 (of 4 total)

This topic contains 4 replies, has 3 voices, and was last updated by  davidp 17 years, 9 months ago.

We moved to new unified forum. Please post all new support queries in our New Forum