Joomla Templates Club 406,261 posts

[ralley Friend ralleyJoin date: October 2006Posts: 56Downloads:0Uploads:0 Thanks: 9]

#150417

I am using ver. 1.1 of the Seleni template and have been having a problem with the wrapper layout not spreading to the full width of the template, even when there are no modules on the right side of the page.

See http://www.petoskey.us/documents/codified-ordinances

Its unclear whether I have a ghost module on the right side keeping the wrapper from spreading the full width, or whether the wrapper is located in the main body and is unable to go wider for some other (coding?) reason. I have played with the width of the wrapper (both pixels and %) with no success.

Any ideas?

[Saguaros Moderator SaguarosJoin date: September 2014Posts: 31405Downloads:237Uploads:471 Thanks: 845 Thanked: 5346 times in 4964 posts]

#340803

Dear ralley!

Because the JW Tabs & Slides Module module is publishing on the right position, but the module did not display content.

If the template have one or modules display on the “right”, then the template ‘ll split two parts:
1) the main container has width 70% of total width
2) the right column has width 30% of total width

I have turned this module .please kindly try to check again

1 user says Thank You to Saguaros for this useful post

1. ralley

[Author]

Posts